Create WIND BRAID Manual Del Usuario página 11

M OUN TI N G AND HANGI NG O F T H E FAN
Lock pin
Before you begin mounting the fan, you must choose the appropriate height for your home.
If you want to extend the hanging length of your fan, remove the hanger bar ball and use the
additional extension bar (included).
1. To remove the hanger ball loosen the set screw and remove the pins.
2. Lower the ball and remove the locking pin.
3. Take out the hanger rod ball and insert it into the longer hanger rod (the top of the rod has
a fixing screw hole, please use it to fix the rod).
4. Insert the locking pin into the end of the suspension rod and raise the ball.
5. Finally make sure that the locking pin is aligned with the slots inside the ball and fix the
set screw.
Advice: To prepare for running electrical wires through the downspout, apply a piece of elec-
trical tape to the ends of the electrical wires, this will hold the wires together when you run
them through the hanger bar.
6. Loosen the mounting bolts and nut at the top of the motor housing.
7. Insert the canopy and fan trim into the hanger bar.
8. Remove the locking pin from the motor body and grasp the down tube to slide the downrod
through the canopy.
9. Route the electrical wires through the down tube and pull the top end of the extra slack
in the wire.
10. Install the motor housing bar and insert pin that was previously removed.
11. Securely tighten the motor mounting bolts and nut.
12. Finally lower the trim and rosette on the motor housing.
Barrette
lock
Cabling
Bar of
suspension
Rosette
Trim
Cap screw
Adapter
Fixing screw
E NGLI SH
11