ADInstruments AD71B Manual De Usuario página 47

_____________________________________________________________________
z In Setup, each press to select the
digit you want to edit.
z In Recall, press to enable SEND
feature (UT71B only)
z In Store, press to toggle between
clearing all the stored reading or
start storing reading from the
current index number. (UT71B
only)
Press to exit certain button functions
and the Meter will return to the factory
default setting.
Press to turn the backlight on. It is
possible to toggle between 1
nd
2 backlight level and Exit the feature
by pressing this button. After exiting
the light feature, it is necessary to
press and hold the button for over 1
second to turn the backlight on again.
Press to display max, min and average
values.
Press EXIT to stop and return to
(UT71A
current measurement mode.
only)
In Setup, each press to decrement an
Option.
Press to display max, min and average
values.
Press EXIT to stop and return to
current measurement mode.
Press to output the data, AUTO mode
switch off. The primary display shows
"SEND".
Press EXIT to exit.
(UT71B
In Setup, each press to decrement an
only)
Option.
In Recall, each press to go back to the
previous stored reading.
In Store, each press to decrease a
second on the storing interval.
Press EXIT to exit
©Copyright Abacanto Digital SA.
st
and the
Manual de usuario AD71B
AD Instruments
Press the button
once after
entering Setup
or Recall or
Store mode.
Press the button
once.
Press and hold
the button for
over 1 second.
Press the button
once.
Press the button
once after
entering SEND
mode.
Press the button
once.
Press and hold
the button for
over 1 second.
Press the button
once after
entering SEND
mode.
47