Introduction; Recalling Stored Readings - ADInstruments AD71B Manual De Usuario

_____________________________________________________________________

Introduction

Chapter 4 shows you how to use stores, recall and communication features available on
the Meter. Please note that Data stores and recall features are available only on the
UT71B.
Store and Clearing Readings
To store readings, proceed as follows:
z Press STORE once, STO and "no.xxxx" appears to confirm the operation and the
left secondary display shows the current measurement reading. Press
toggle between clearing the stored readings and start from the first readings or
start from the last stored reading. Right secondary display shows the original
number of records.
z Press STORE the second time, STO appears. The left secondary display shows
the storing time interval in second, it is preset to zero. To change the interval in
second by pressing + or - button. The interval can be as high as 255 seconds or
as low as 0 second.
z Press STORE the third time, STO and no appears.
shows the index number increase one. The right secondary display shows the
value of the corresponding index number, the primary display shows the current
measurement reading.
z If there is not set time to store the reading, each press of STORE to store one
reading. An index number increase one.
The maximum number of stored reading is 100 (for UT71C and UT71E) and 9999
z
(for UT71D). When the stored readings memory is full,
data.
z To exit, press EXIT.
z Automatic power off feature will be disabled after entering this mode.

Recalling Stored Readings

Use the following procedure to recall the stored reading:
z Press RECALL to recall the stored value and RCL appears to confirm the operation.
z The left secondary display shows the index number "no.xxxx".
z The primary display shows the corresponding recalled data.
z The right secondary display shows the total number of the stored data.
z Press button to enable the SEND feature to export the data to the computer via
USB. The software shows the data storing time and also the data value.
the data transferring is completed, the SEND feature will be disabled automatically.
z Press + or - button to view additional stored reading.
access quick recalling.
z Press EXIT to exit recalling.
©Copyright Abacanto Digital SA.
Using Store, Recall & Send Features
Press and hold STORE to access the quick setting.
Manual de usuario AD71B
AD Instruments
Chapter 4
The left secondary display
the Meter will stop storing
Press and hold RECALL to
to
After
61