GE 21 Manual Del Propietario Y Instalación página 32

Installation Instructions
REPLACING THE DOORS
(Double Door Refrigerator Models only)
[] INSTALL CENTER HINGE
Install the center hinge on each side.
[] REHANG REFRIGERATOR DOORS
[] Lower the refrigerator door onto the
center hinge pin. Ensure that the plastic
hinge pin thimble is on the center hinge
pin or inside door hinge pin hole located
in the bottom of the door.
Hinge Pin _
[] Securely tape the door shut with masking
tape or have a second person support
the door.
[] Route wires through bottom right hinge
pin slot. Insert the top hinge pin into the
hinge hole on top of the refrigerator door.
Make sure the door is aligned with the
cabinet and opposite door. Attach the
hinge to the top of the cabinet loosely
with the bolts.
Bottom
Right Hinge
Pin Slot
(appearance may vary)
[] On right-hand doors, pass the wires and
water line through the center hinge pin.
Then connect the water line and 4-pin
connector.
Center
Hinge Pin
4-Pin
"-_Water Connector
32
[]
[]
REHANG REFRIGERATOR DOORS(CONT.)
Make sure the gasket on the door is
flush against the cabinet and is not folded.
Make sure the door is straight and the gap
between the doors is even across the front.
While holding the aligned door in place,
tighten the top hinge bolts. Replace the
hinge cover and screw.
H,n0e Cover-- o
Top Hinge Bolt_
(appearance may vary) .._/-_J
[]
REPLACE OPPOSITE DOOR
Follow the same procedure on the
opposite door. There is no water line or
hinge cover.
[]
ALIGN DOUBLE DOORS
If the top of the doors are uneven, first
try to raise the lowest door by turning the
leveling leg on the same side as the door
until the doors are even. If the unit rocks,
re-adjust the leveling legs to the extent
that the unit is stable.
If the doors remain uneven, turn the
adjustable pin to raise, or lower, the left
door to match the right door. Use a 1/4"
Allen wrench to turn the pin.
[] REPLACE FREEZER DRAWER
Refer to the Replacing the Freezer Drawer
section for instructions.