Publicidad
Idiomas disponibles
Idiomas disponibles
CRAFTSMAN
FULL WARRANTY
If this Craftsman product fails due to a defect in material or workmanship
within two years from the date of purchase, return it to any Sears store, Parts &
Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement
if repair proves impossible).
This warranty applies for only 90 days from the purchase date if this product is ever used for commercial or rental purposes.
This warranty
covers
ONLY defects
in material
and workmanship.
Sears will NOT pay for:
*
Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
*
Repairs necessary because of accident or failure to operate or maintain the product according
to all supplied instructions.
*
Preventive maintenance,
or repairs necessary due to improper fuel mixture, contaminated
or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
APPLICATIONS
As a trimmer:
*
Cutting grass and light weeds
Edging
*
Decorative trimming around trees, fences, etc.
Other optional accessories may be used with this unit.
D-Handle
Muffler
Shaft Grip
On/Off
Control
\
Spark Plug
Starter
Rope
Grip
Fuel Cap
Air Filter
Cover
Shaft Housing
Throttle
Control
Cutting
Head Shield
Convertible
TM
Coupler
Primer
Cutting
Line
Cutting
Blade
_
INSTALL CUTTING HEAD SHIELD
INSTALL AND ADJUST THE D-HANDLE
m
_L_
ARNING:
To prevent serious personal injury, never operate
the trimmer without the cutting head shield in place.
Use the following
instructions
if the cutting head shield on the unit is not
installed.
Screw
(2}
1.
Place the cutting head shield
\\
A
onto the guard mount
\\
bracket, making sure to align
Cutting
Guard
the holes on the shield with
Head Shield
\ \
_
Mount
the ones in the guard mount
\
\___
Bracket
bracket. (Fig. 1)
2.
Take the 2 shield screws and
screw each one into the
shield until finger tight.
3.
Using an appropriate screw
driver, tighten the screws until
the shield is firmly in place.
Fig. I
1.
Push the D-handle down onto
Shaft Grip
Shaft Housing
the shaft housing (Fig. 2). The _
j
hex bolt hole in the handle
_--___
D-Handle
should be on the left side.
2.
Insert the bolt into the hex
hole in the handle and push
_'"Xj_:_...._X_
Tighten
through. Place the washer on
Minimum 6 in.
_X-_"/_:_L"_r'_
Wing
the bolt, then screw the wing
nut onto the bolt. Do not
(15.24 cm)
j_'_
Nut
tighten until making the
handle adjustment.
Bolt _
Washer
3.
Rotate the D-handle to place
Fig. 2
the grip above the top of the
shaft housing. Place it a minimum of 6 inches (15.24 cm) from the end
of the shaft grip.
4.
While holding the unit in the operating position (Fig. 10), move the D-handle
to the location that provides the best grip.
5.
Tighten the wing nut until the D-handle is secure.
Publicidad
