Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Method 2:
a) Turn power to off ("O") position,
disconnect power cord.
b) Ensure drum is empty.
c) Positioned on side of mixer, grab front
and lift rear leg of mixer off the ground.
Be careful not to tip mixer on yourself.
d) Move mixer to desired location.
3. Cement mix instructions
NOTE: Refer to instructions from the cement mix manufacturer.
4. Pre-mixed cement mix instructions
NOTE: Refer to instructions from the pre-mix cement mix manufacturer.
CARE AND MAINTENANCE
AFTER USE: Clean out the drum with water. If cement has dried to the inside of mixer,
tap the outside of the drum with a rubber or plastic mallet. Dump mixer to empty dried
cement from drum (DO NOT use a steel hammer to dislodge dried cement from mixer).
Lightly grease all moving parts.
The gearbox is sealed for life. Do not attempt to open the gearbox and change the oil.
This is not necessary, and doing so will void the warranty. Keep the motor assembly
clean and free of build up. Wipe the on/off switch assembly and motor with a lightly
dampened cloth. DO NOT spray water directly onto motor. Protect motor assembly from
rain. Store mixer indoors. Please use caution when dumping the contents of the mixer.
The motor should be in the OFF position when emptying the mixer.
METHOD 2
Method 2
10
Publicidad
