Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
NOTE
Fasteners should only be tightened after final
alignment achieved.
1. Attach bottom casting (A) to rear leg (D) using two
M8 × 45 bolts (EE) and two M8 nuts (HH). Attach
rear leg cross member (E) to rear leg (D) using two
M8 × 60 bolts (FF) and two M8 nuts (HH).
DO NOT COMPLETELY TIGHTEN.
HARDWARE USED
M8 × 45mm Bolt
EE
M8 × 60mm Bolt
FF
M8 Nut
HH
2. Slide pivot pin (L) through bottom casting (A) and
front legs (H). Insert cotter pins (JJ) into pivot
pin (L). Be sure to secure cotter pins (JJ) properly
into pivot pin (L) before moving onto next step.
HARDWARE USED
JJ
Cotter Pin
3. Assemble lower frame support (I) to front legs (H)
using two M8 x 45 mm bolts (EE) and
M8 nuts (HH). Slide M8 x 70 mm (QQ) bolt through
bottom link of chain (PP). Assemble lower frame
support (I) to rear leg (D) using M8 x 70 mm
bolt (QQ) and M8 nut (HH). Attach carabiner (OO)
to other end of chain.
DO NOT COMPLETELY TIGHTEN.
HARDWARE USED
M8 × 45mm Bolt
EE
Chain
PP
M8 x 70 mm Bolt
QQ
with washer
M8 Nut
HH
Carabiner
OO
4. Assemble front cover (K) to front legs (H) using four
M8 × 40 mm bolts (DD) and M8 nuts (HH).
HARDWARE USED
M8 × 40mm Bolt
DD
M8 Nut
HH
2
2
4
2
2
1
1
3
1
4
4
1
FF
2
3
4
HH
DD
7
HH
HH
E
JJ
L
JJ
H
EE
QQ
H
PP
HH
D
OO
K
K
A
EE
D
A
H
D
EE
H
I
Publicidad
