Publicidad
Idiomas disponibles
Idiomas disponibles
HARDWARE CONTENTS (NOT TO SCALE)
Part Description
AA
M10 Nut
M10 Flat
BB
Washer
CC
Shoulder Bolt
DD
M8 × 40mm Bolt
EE
M8 × 45mm Bolt
FF
M8 × 60mm Bolt
GG
Motor Shaft Pin
HH
M8 Nut
End Cap
II
(Pre-installed)
SAFETY INFORMATION
Follow owner's manual to ensure proper assembly of mixer, using the parts list in
conjunction with procedures.
•
Retain these Instructions for future reference.
•
Parts may have sharp edges. Wear gloves when assembling the mixer.
•
Store appliance indoors when not in use.
•
Keep out of reach of children.
• Carefully read the caution and warning messages.
• Review these instructions before operating mixer.
• All bolts should be fastened with the nuts facing toward the center of the mixer.
• Do not tighten fasteners until final alignment is achieved.
• Safety glasses and gloves should be worn while operating this mixer.
• All wiring, electrical connections, and system grounding must comply with the National
Electrical Code (NEC) and with any local codes and ordinances. Contact a local
licensed electrician for further information.
• Do not expose to rain, store indoors.
• A ground fault interrupter (GFI) protected circuit is recommended for all outdoor
electrical devices.
• Keep motor operating area as dry as possible.
• Always disconnect the power before servicing.
Quantity Picture
2
2
2
5
7
2
1
19
2
CAUTION - ALWAYS START MIXER EMPTY
WARNING - ELECTRICAL PRECAUTIONS
WARNING - RISK OF ELECTRICAL SHOCK
Part Description
JJ
Cotter Pin
KK
M8 U-Bolt
M8 Nut
LL
(Pre-installed)
M8 Flat Washer
MM
(Pre-installed)
M8 Spring Washer
NN
(Pre-installed)
OO
Carabiner
PP
Chain
QQ
M8 x 70 mm Bolt
with washer
RR
Single Chain Link
4
Quantity Picture
3
2
4
4
4
1
1
1
1
Publicidad
