Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
5. Assemble wheels (B) to mixer frame using shoulder
bolt (CC), M10 flat washer (BB) and M10 nut (AA).
Tighten wheel bolts. Set mixer frame on level surface.
Make sure crossmember (E) is steadily seated on the
ground. Slide end cap (II) onto rear leg cross
member (E). MAKE SURE ALL SCREW HOLES AND
SCREWS ALIGN PROPERLY. PROPERLY TIGHTEN
ALL SCREWS USED IN STEPS 1 - 5.
HARDWARE USED
AA
M10 Nut
M10 Flat
BB
Washer
CC
Shoulder Bolt
II
End Cap
6. Attach drum support arm (G) to handle (F) using
M8 × 40 mm bolt (DD) and M8 Nut (HH). Insert
M8 x 45mm bolt (EE) into drum handle (J). Slide
the single chain link (RR) onto bottom of
M8 x 45mm bolt. Screw on M8 nut (HH).
NOTE: Make sure single chain link is facing the
same direction as the chain links you attached to
the lower frame support (D). Assemble dump
handle (J) to drum support arm (G) using two
M8 × 45 mm bolts (EE) and two M8 nuts (HH).
DO NOT COMPLETELY TIGHTEN.
HARDWARE USED
M8 × 40 mm Bolt
DD
M8 × 45 mm Bolt
EE
M8 Nut
HH
7. Assemble motor (N) to handle (F) and drum support
arm (G) using M8 nut (LL), M8 spring washer (NN)
and M8 flat washer (MM). After aligning all holes
from motor housing to drum support arms properly,
tighten all screws from motor housing to mixer arm
supports securely.
TIGHTEN ALL FASTENERS FROM STEPS 6 & 7.
HARDWARE USED
M8 Nut
LL
M8 Flat
MM
Washer
M8 Spring
NN
Washer
8. Assemble U-Bolt (KK) to drum support arm (G) using
two M8 nuts (HH). Do not completely tighten. Slide
onto pivot pin (L). Insert U-Bolt (KK) into handle (F).
Attach two M8 flange nuts (HH) to U-Bolt.
TIGHTEN ALL SCREWS.
HARDWARE USED
M8 U-Bolt
2
KK
M8 Nut
4
HH
2
2
2
2
HARDWARE USED
1
Single Chain Link
RR
3
3
4
4
4
5
cc
II
6
J
RR
HH
7
1
N
8
8
AA
BB
E
HH
F
EE
G
LL
F
LL
NN
MM
F
L
G
B
cc
II
DD
NN
MM
G
HH
KK
Publicidad
