Selecting Mode - Panasonic EY7549 Manual De Instrucciones

NOTE:
When the brake operates, a braking
sound may be heard. This is normal.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not sig-
nal a malfunction.
* This lag occurs as the tool's circuitry
starts up when the trigger is pulled for
the first time after installing a new bat-
tery pack or after the tool has not been
used for at least 1 minute (or at least 5
minutes when the LED is on). Rotation
will start without any lag during second
and subsequent operations.
Switch and Forward/Reverse
Lever Operation
Forward
Switch lock
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the amount
of depression of the trigger for efficient
tightening of screws and drilling. The
brake operates and the chuck stops
immediately when the trigger is re-
leased.
4. After use, set the lever to its center po-
sition (switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation.
Check the direction of rotation before
use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center po-
sition (switch lock).

Selecting Mode

Select mode Intended use Work material Maximum size
Impact
Drill driver
High mode
Drill driver
Low mode
Reverse
WARNING!
This tool must not be used as a drill in
"Impact Driver mode". During drilling in
steel, the drill bit may break in case of
blocking and this may cause dangerous
cut wounds.
Impact Driver Operation
Select Impact with the mode select
switch.
• Switch to the Impact or Drill driver
High/Low position only when the tool
has completely stopped rotating.
Damage may be caused if the tool is
rotating.
- 9 -
Fastening Bolt
Nut
Driving Wood screw
Self-drilling screw
Driving Wood screw
Self-drilling screw
Drilling Wood
Metal
Driving Wood screw
Drilling Wood
Metal
High tensil:M12
Standard :M14
ø
9mm
ø 6mm
ø
4.2mm
ø
6mm
ø
21mm
ø
10mm
ø
6.8mm
ø 35mm
ø 13mm