Optional Accessories - Makita DHS660 Manual De Instrucciones

MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
CAUTION:
Clean out the upper and lower
guards to ensure there is no accumulated saw-
dust which may impede the operation of the lower
guarding system. A dirty guarding system may limit
the proper operation which could result in serious
personal injury. The most effective way to accomplish
this cleaning is with compressed air. If the dust is
being blown out of the guards, be sure the proper
eye and breathing protection is used.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Adjusting 0°-cut or 45°-cut accuracy
This adjustment has been made at the factory. But if it is
off, you can adjust it as the following procedure.
1. Loosen the lever and clamping screw on the
front and rear of the tool so that the bevel angle can be
changed. Set the stopper to 0° - 45° bevel angle posi-
tion if you are going to adjust 45°-cut accuracy.
► Fig.45: 1. Stopper
2.
Make the base perpendicular or 45° to the circular
saw blade using a triangular rule by turning the adjust-
ing screw with a hex wrench. You can also use a square
rule to adjust 0° angle.
► Fig.46: 1. Triangular rule
► Fig.47: 1. Adjusting screw for 0° angle 2. Adjusting
screw for 45° angle
3.
Tighten the lever and clamping screw and then
make a test cut to check if desired angle is obtained.
Adjusting the parallelism
This adjustment has been made at the factory. But if it is
off, you can adjust it as the following procedure.
1. Set the tool to the maximum cutting depth.
2. Make sure all levers and screws are tightened.
Slightly loosen the screw illustrated.
► Fig.48: 1. Screw 2. Base
3. While opening the lower guard, move the rear of
the base so that the distance A and B becomes equal.
4.
Tighten the screws and make a test cut to check
the parallelism.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Circular saw blade
• Rip fence (Guide rule)
• Hook
• Guide rail
• Bevel guide
• Clamp
• Sheet
• Rubber sheet
• Position sheet
• Guide rail adapter
• Rule bar
• Dust nozzle
• Hex wrench
• Wireless unit (for DHS661)
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
20 ENGLISH