Troy-Bilt 020241 Instrucciones De Uso página 7

Assembly
3
ASSEMBLY
IMPORTANT: Read entire operator's manual before
you attempt to assemble or operate your new pressure
washer.
Remove Pressure Washer from
Carton
1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
3. Remove pressure washer from carton.
Carton Contents
Items in the carton include:
• Main Unit
• Handle
• Plastic Accessory Tray
• High Pressure Hose
• Spray Gun
,, Nozzle Extension with Quick Connect Fitting
• Oil Bottle
• Parts Bag (which includes the following):
• Operator's Manual
• Engine Manual
• Emissions Control Warranty Sheet
• Owner's Registration Card
• Safety Goggles
• Bag containing 4 multi-colored Quick Connect
Spray Tips
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolt
• "1" Bolt (2)
• Plastic Knobs (3)
• Tree Clips (4)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged,
call the pressure washer helpline at 1-888-611-6708.
To prepare your pressure washer for operation,
you will need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle to main unit, then attach accessory
tray to handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and
pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle and Accessory Tray
1. Place handle onto handle supports connected to
main unit. Make sure holes in handle align with
holes on handle supports (Figure 1).
Handle
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
O