How To Use Accessory Tray; Low Pressure; High Pressure; How To Use Spray Tips - Troy-Bilt 020241 Instrucciones De Uso

Section 4: Operation
How to Use Accessory Tray
The unit is equipped with an accessory tray with
places to store your spray gun and nozzle extension.
There is also a hook at the front of the accessory tray
to hold your high pressure hose.
NOTE: The extra hole in the tray is for storing a utility
brush. The extra clip in the tray is for storing a turbo
nozzle. The brush and turbo nozzle are NOT included
with your pressure washer. You can buy these items as
optional accessories.
1. Place nozzle extension through hole on accessory
tray, as shown in Figure 12.
2. Place spray gun through hole on accessory tray
on right side of unit (Figure 12).
NOTE: You may also use the hooks attached to the
base and handle to store your gun and nozzle
extension, as shown on page 6.
3. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown in Figure 12.
How to Use Spray Tips
The quick-connect on the nozzle extension allows you to
switch between four different quick connect spray tips. The
spray tips vary the spray pattern as shown (Figure 13).
I CAUT, ON 1
NEVER exchange spray tips without locking the trigger
lock on the trigger.
Follow these instructions to change spray tips:
1. Engage trigger lock on spray gun.
2. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in slots on holder
that's attached to nozzle extension.
3. Select desired spray tip:
For gentle rinse, select white 40 ° spray tip.
To scour surface, select yellow 15° or red 0 °
spray tip.
To apply detergent, select black spray tip.
Low Pressure
Black
Use to apply
detergent
High Pressure
40 ° White 15 ° Yellow 0 ° Red
4. Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
5. For most effective cleaning, keep spray tip from
8 to 24 inches away from cleaning surface. If you
get spray tip too close, you may damage cleaning
surface.
6. DO NOT get closer than 6 inches when cleaning
ti res.
O