Connect Hose And Water Supply To Pump; Important; Checklist Before Starting Engine - Troy-Bilt 020241 Instrucciones De Uso

Section 3: Assembly
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must
assemble the nozzle extension to the spray gun and
attach all hoses before you start the engine.
1. Attach one end of high pressure hose to high
pressure outlet on pump (Figure 4). Tighten by
hand.
2. Attach other end of hose to base of spray gun
(Figure 5). Tighten by hand.
3.
Before connecting garden hose to water inlet,
inspect inlet screen (Figure 6). Clean screen if it
contains debris, replace if damaged. DO NOT
RUN PRESSURE WASHER IF SCREEN IS
DAMAGED OR MISSING.
4. Run water through garden hose for 30 seconds to
clean out any debris. Turn off water.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than IO0°F).
5. Connect garden hose (not to exceed 50 feet in
length) to water inlet.Tighten by hand (Figure 6).
CAUTION
,, Damage to equipment resulting from failure to follow
this instruction will void warranty.
6. Turn ON water and squeeze trigger on spray gun
to purge pump system of air and impurities.
WARNING
Always wear safety goggles when using this equipment
or in vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are
wearing adequate safety goggles.
Checklist Before Starting Engine
Review the unit's assembly to confirm you have
performed all of the following:
1. Make sure handle is in place and secure.
2. Check that oil has been added to proper level in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for properly attached hose connections.
5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water supply at an adequate flow.
7. Be sure to read "Safety Rules" and "How To Use
Your Pressure Washer" before using pressure
washer.
O