Power On/Off - LD Systems ROADJACK 8 Manual De Usuario

CONNECTIONS, CONTROLS, AND INDICATORS:
14
115 V / 230 V
Switch for setting the operating voltage. The mains voltage of your power supplier and the operating voltage
of the device must be the same!
15
IEC POWER SOCKET WITH INTEGRAL FUSE HOLDER
Used to power the device. An appropriate power cord is included in the delivery.
IMPORTANT INFORMATION: BEFORE using this equipment, make certain that the mains voltage of your
energy supplier and the operating voltage of the device match! Always replace the fuse with a fuse of the
same type and rating according to the supply voltage (see label on the rear panel)!
If the fuse blows repeatedly, please contact an authorised service centre.
16
POWER ON / OFF
On / Off switch for the power supply of the device.
17
CHARGE-LED
Lights up while charging the internal battery. When the battery is fully charged, the CHARGE LED goes out. To
charge the battery, an appropriate power cord must be connected to the power socket (No. 24) of the device.
18
BATTERY LEVEL LEDS
4-segment LED meter displays the charge status of the built-in battery. When all three green LEDs are lit, the
battery is fully charged. The battery is discharged when the red LED is lit.
NOTE TO BATTERY CARE (LEAD BATTERY)
Recharge the battery fully at every opportunity. Never completely discharge a rechargeable lead battery or store
it in discharged or semi-charged condition. During extended periods of disuse and storage, the battery must be
recharged fully at regular intervals.
9