Remote Control - Sony HT-S200F Manual De Instrucciones

 If the system is installed under the TV,
move the system away from the TV.
 Reposition the connected
BLUETOOTH device.
 Switch the wireless LAN frequency of
any nearby wireless LAN router or PC
to 5 GHz range.
 Increase the volume on the
connected BLUETOOTH device.
The sound is not in sync with the
image.
 When you are watching movies, you
may hear the sound with a slight
delay from the image.

Remote Control

The remote control of this system
does not function.
 Point the remote control at the
remote control sensor on the Bar
Speaker (page 8).
 Remove any obstacles in the path
between the remote control and the
system.
 Replace both batteries in the remote
control with new ones, if they are
weak.
 Make sure you are pressing the
correct button on the remote control
(page 12).
The TV remote control does not
work.
 Install the Bar Speaker so that it does
not obstruct the remote control
sensor of the TV.
 This problem might be solved by
enabling the IR repeater function
(page 18).
Others
The Control for HDMI function does
not work properly.
 Check the connection with the system
(refer to the supplied Startup Guide).
 Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.
 Wait a while, and then try again. If
you unplug the system, it will take a
while before operations can be made.
Wait for 15 seconds or longer, and
then try again.
 Make sure the devices connected to
the system support the Control for
HDMI function.
 Enable the Control for HDMI function
of the devices connected to the
system. For details, refer to the
operating instructions of your device.
 The type and number of devices that
can be controlled by the Control for
HDMI function is restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to
3 devices
– Playback devices (Blu-ray Disc
player, DVD player, etc.): up to 3
devices
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphone): up to 1 device (used by
this system)
All indicators on the Bar Speaker
flash for 10 seconds and the system
is turned off.
 The protection feature is activated.
Disconnect the AC power cord (mains
lead) and check the items below.
– Make sure that the ventilations of
the Bar Speaker are not covered and
turn on the system after a while.
– When the system is using the USB
connection, remove the USB device
and turn on the system. If the
system operates properly, the
current of the connected USB device
is over the maximum output current
of the system 500 mA, or the USB
device may have an abnormality.
33
US