GB
Milk frother
Dear Customer,
Before using the appliance, read the
following instructions carefully and keep this
manual for future reference. The appliance
must only be used by persons familiar with
these instructions.
Connection to the mains supply
The appliance should only be connected to
an earthed socket installed in accordance
with the regulations. Make sure that the
supply voltage corresponds with the voltage
marked on the rating label of the appliance.
This product complies with all binding CE
labelling directives.
Familiarisation
1.
Lid
2.
Milk container with handle
3.
Power cord with plug
4.
Base
5.
Stirring insert without coil for heating
milk
6.
Holder for stirring insert
7.
Stirring insert with coil for frothing milk
8.
Plastic spatula
9.
Rating label (underneath the base)
10. On/Off switch
Important safety instructions
∙ In order to avoid hazards,
repairs to this electrical
appliance or its power
cord must be carried out
10
by our customer service.
If repairs are needed,
please send the appliance
to our customer service
department (see appendix).
∙ Before cleaning the
appliance, ensure it is
disconnected from the
power supply and has
cooled down completely.
∙ To avoid any risk of electric
shock, do not clean the
appliance with liquids or
immerse it in a liquid.
∙ The milk container must be
cleaned immediately after
use. Detailed information on
cleaning can be found in the
section Cleaning and care.
∙ The milk frother must only
be used on its designated
base.
∙ The electrical connection in
the base must be protected
at all times against possible
contact with water.