Main Screen/Mixer Mode/Preset Management; Main Screen - Ecler DAM514 Manual De Instrucciones

6. MAIN SCREEN/MIXER MODE/PRESET MANAGEMENT

6.1. MAIN SCREEN

After power on, the screen of the device displays the following information for a few seconds...
...then shows other information similar to this one:
Z A
P 0 1
The information available on this screen, or main screen, is as follows (according to the example
above:

ZA: selected output zone for volume adjustment, selection of sources, etc. The available
zones are ZA, ZB, ZC, ZD (all mono) or ZAB and ZCD if any pair of outputs is configured
as a stereo zone

OUTPUT 1: name of the output zone, by default OUTPUT n, but it is editable

P01: number of the active preset or template. An asterisk to the right of the preset number
indicates that this preset has been modified and not yet re-saved in the DAM514 memory
(your changes will be lost when you shut down the computer if they are not saved
before...)

Horizontal Volume Bar: displays the output volume of the relevant zone; it can be directly
altered by rotating the digital encoder
When the displayed output zone has been assigned to a volume control from an external wall
panel (WPm series or similar) connected to a REMOTE port of the DAM514 back panel, any modification
of the physical remote panel position will briefly display the relevant volume setting on the LCD screen
(before return to the main screen):
Z 3
P 4 *
In addition, the front panel input and output keys use their backlight to give the following
information:

Inputs:
Input enabled for the output zone displayed on screen. A short press on the key
switches its status (active/inactive)
Input disabled for the output zone displayed on screen. A short press on the key
switches its status (active/inactive)

Outputs:
Muted output (MUTE=ON). A long press (> 2 seconds) on the key switches its status
(unmuted/muted)
12
D A M 5 1 4
L O A D I N G . . .
O U T P U T
R E M O T E
1
V O L U M E