Installing/Replacing Batteries - Philips SHC8680/61 Instrucciones De Manejo

SHC8680new.qxd 04-05-2005
8 ENGLISH
Ni-MH
Type: . . . .
Input: . . . .
Output: . . . .
TRANSMIT CHARGING
10:23 Pagina 8

Installing/replacing batteries

1 Open the battery compartment door located at the bottom of the
receiver unit.
2 Insert a rechargeable battery.
3 Make sure the battery is correctly inserted as indicated by the engraved
polarity symbol in the battery compartment.
4 Close the battery compartment door.
Power up the transmitter station
5 Make sure the adapter's rated voltage indicated on the type plate
corresponds to the mains voltage supply.
6 Connect the DC power output connector of the 12 Volt/ 200mA AC/DC
adapter to the DC POWER INPUT jack at the back of the transmitter.
7 Connect the 12 Volt/200mA AC/DC adapter to the mains socket.
Always remove the adapter from the mains socket if the transmitter will not
be used for a period of time.
Charging the receiver unit
8 Open the lid of the transmitter station.
9 Place the receiver unit into the transmitter station (will also be referred
to as the 'energizing docking station' in the following texts).
10 Make sure the charging contacts at the bottom of the receiver unit are
well aligned with the charging pins of the docking station.
11 Close the lid of the docking station.
12 The CHARGING INDICATION on front of the docking station will be
illuminated in green, and will be turned off automatically at the end of the
charging cycle.