PW3500
6.6
Changing the batteries in the wind sensor
I
NOTE
When the batteries of the wind sensor are running low, the wind sensor
indicates this with a brief beep tone which is repeated every 5 seconds.
The awning also retracts automatically after 30 minutes, even if it is not
windy.
➤ Extend the awning if required.
➤ Move the wind sensor (fig. 5 1, page 3) on the inside of the front cover to the
left and take it off.
➤ Release the sensor insert (fig. 6 A, page 3).
➤ Remove the sensor insert from the housing (fig. 6 B, page 3).
I
NOTE
Do not use rechargeable batteries.
➤ Replace the used batteries with new AAA or LR03 (1.5 V) alkaline batteries
(fig. 6 C, page 3). Make sure the polarity is correct.
✓ Once the new batteries have been inserted correctly, a brief beep tone is
emitted.
If this does not happen, check the positioning of the batteries.
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of them at
collection points.
➤ Test the wind sensor (chapter "Testing the wind sensor" on page 13).
➤ If the wind sensor does not work, reprogramme it (chapter "Reprogramming the
wind sensor" on page 17).
EN
Operating the awning
15