Before Use; Handling Of The Packed Machine; Unpacking Of The Machine; Battery Installation And Setting Of The Battery Type - ADIATEK jade 55c Instrucciones De Uso Y Mantenimiento

GB

BEFORE USE

HANDLING OF THE PACKED MACHINE

The machine is supplied with suitable packing fore-
seen for fork lift truck handling.
The total weight is 122 kg.
Packing dimensions:
Base: 138 cm x 67 cm
Height: 119 cm
ATTENTION:
Do not place more than 2 packings on top of each
other.

UNPACKING OF THE MACHINE

1. Remove the external packing.
2. Unscrew the brackets (1+2) that secure the ma-
chine to the pallet.
3. Move the machine backwards, as indicated in the
figure, avoiding heavy contacts to mechanical parts.
4. Keep the pallet and the brackets for eventual
transport.
BATTERY INSTALLATION AND SETTING OF THE
BATTERY TYPE
This machine is equipped either with two batteries at
12V in serial connection or elements of DIN-type as-
sembled together and connected in series for a total
of 24 Volt, placed in its appropriate compartment
under the recovery tank and must be handled using
suitable lifting equipment (due to weight, consider-
ing the type of batteries chosen, and coupling sys-
tem).
The batteries must be in accordance with CEI 21-5
Norms.
For batteries installation proceed as follows:
1. Take off the squeegee hose (1).
2. Take off the suction cover (2) after turning the
blocking levers (3).
3. Lift the recovery tank by rotating it and fix it
with the suitable bar (4).
4. Place the batteries in its compartment.
5. Connect the terminals, respecting the polari-
ties, avoiding contact with other parts that could
create short circuit.
6. Reassemble all parts.
ATTENTION:
The machine and its battery check card foresee the
use of traditional lead batteries.
CHECK SETTING OF THE CHECK CARD ON THE INDI-
CATOR (1).
In case of GEL batteries installation, it is necessary to
set the battery check card. Please contact the au-
thorized technical assistance.
ATTENTION:
Strictly follow manufacturer/distributor indications
for the maintenance and recharge of the batteries.
All installation and maintenance operations must be
executed by specialized staff, using suitable protec-
tion accessories.

BATTERY RECHARGER

Be sure that the battery recharger is suitable for
the installed batteries both for their capacities
and type (lead/acid or GEL and equivalent).
In the plastic bag containing the use and mainte-
nance you will find the coupling connector for the
recharger. It must be assembled onto the cables of
your recharger, following the instructions given by
the manufacturer.
ATTENTION:
This operation must be carried out by qualified staff.
A wrong or faulty cable connection can create seri-
ous damages to persons or things.
INCORPORATED BATTERY RECHARGER (OPTION-
AL)
If the machine is equipped with the incorporated
battery recharger (see under "OPTIONAL ACCESSO-
19
RIES") please refer to the instructions of the con-
structor of this accessory what the recharging op-
erations concern.
The battery recharger is connected directly to the
battery poles.
During the recharging operations a device is activat-
ed which does not permit the machine's functioning.
The mains cable of the battery recharger has a max-
imum length of two metres and must be connected
to a single-phase socket type CEE 7/7.

BATTERIES RECHARGING

Bring the machine on a levelled surface.
1. Plug in batteries connector (1) placed in the rear
part of the machine, to the connector (3) of the bat-
tery recharger.
2. Proceed to the recharging keeping the tank lifted
(see under paragraph "BATTERY INSTALLATION AND
SETTING OF THE BATTERY TYPE" in "BEFORE USE").
3. Maintain the connection with the battery re-
charger until the indication of the end of charge is
not visualized.
BATTERIES RECHARGING WITH INCORPORATED
BATTERY RECHARGER (OPTIONAL)
Bring the machine on a levelled surface near to a
single-phase socket with tension 230V, frequency
50Hz, nominal current 10A.
Switch off the switches of the brushes motor and
the suction motor.
1. Insert the plug into the mains socket.
2. Proceed to the recharging keeping the tank lifted
(see under paragraph "BATTERY INSTALLATION AND
SETTING OF THE BATTERY TYPE" in "BEFORE USE").
3. Do not take off the plug from the mains socket
until the indication of the end of charge is not visu-
alized.
At the end of the recharging, take off the plug from
the mains socket.
GB