Machine And Tool Care - Virax VULCA D160 Manual De Instrucciones

residues on the heating plate reduce the anti-adhesive properties and must be removed
with non-fuzzy paper and alcohol.

The trimmer is equipped with two double-sided ground knives. When cutting capacity
starts decreasing, the knives can be turned over or replaced by new ones.

It must always be ensured that the pipe or workpiece ends to be machined, especially the
face surfaces, are free of soiling because otherwise the service life of the knives will be
shortened.
It is recommendable to have repairs done only by a service workshop or by the
manufacturer.
4.1

Machine and tool care

(Follow the maintenance instructions in item 4!)
Sharp and clean tools produce better work results and are safer.
Replace blunt, broken or lost parts immediately. Check whether the accessories are securely
connected to the machine.
Use only original spare parts from the manufacturer for maintenance work. Repairs must be
carried out only by professionally qualified personnel.
Disconnect the machine from the mains when it is not in use, prior to care and maintenance
work and before changing accessory parts.
Prior to reconnection to the mains, it must be ensured that the machine and the accessory
tools are switched off.
When extension cables are used, they must be checked for their safety and operativeness.
Only cables approved for outdoor use must be used.
Tools and machines whose housing or handles, especially those made of plastic, are cracked
or warped must not be used.
Dirt and moisture in such cracks conduct electric current. This can lead to an electric shock if
the insulation is damaged in the tools or in the machine.
Note: Furthermore, we refer to the accident prevention regulations.
5 Disposal
Components of the unit are recyclable material and should be put to recycling. For this
purpose registered
environmentalfriendly disposal of the non-recyclable parts (e.g. electronic waste) please
contact your local waste disposal authority.
For EU countries only:
20
and certified
Do not dispose of electric tools with domestic waste. In accordance with European
Directive 2002/96/EC on waste electrical and electronic equipment and its
implementation as national law, electric tools that are no longer serviceable must
be collected separately and utilised for environmentally compatible
recycling companies are available. For
recycling.
an