Mafell PSS 3100 SE Manual De Instrucciones página 32

Defect
Feed drive cannot be switched on
Feed drive does not switch off if
end position is approached
Feed speed cannot be controlled
Saw unit stops while cutting is in
process
Saw blade jams during saw unit
advance
Burn marks on the cut surfaces
Chip ejection blocked
Cause
No mains voltage
Mains fuse defective
Saw unit has driven against limit
switch at the stop slide or at the
operator panel
Limit switch at stop slide or
operator panel defective
Limit switch at stop slide or
operator panel defective
Control (e.g. control dial) defective
Mains failure
Selected feed speed too high
Selected feed speed too high
The saw blade used is unsuitable
for the material or blunt
Tension in the workpiece
The saw blade used is unsuitable
for the task or blunt
Feed speed too low
Wood is too damp
Cutting without extraction
External extraction too weak
-32-
Disposal
Check power supply
Replace fuse
Initiate infeed counter movement
Take the machine to a MAFELL
customer service shop
Take the machine to a MAFELL
customer service shop
Take the machine to a MAFELL
customer service shop
Check mains back-up fuses
Reduce feed speed
Reduce feed speed
Immediately stop the infeed and
saw blade drive by releasing the
switch. Remove the machine from
the workpiece and replace the saw
blade
Riving knife / splitter not available
contrary to the regulations. Stop
system as described above and by
all means use riving knife / splitter
Replace saw blade
Increase feed speed
Use external extraction, e.g. small
dust collector
Use stronger external extraction
Before turning
again, the extraction hose between
chip outlet, saw unit and chip
channel must be pulled off and
cleaned
on