DJ-Tech X10 Manual De Instrucciones página 5

Example 2 Deckadance
Example 3 Virtual DJ
5. The included Deckadance LE software
Insert the Deckadance LE Setup CD into computer CD-ROM.
i) For PC, click "INSTALL DECKADANCE" in the Autorun menu screen or double click the "Menu.exe" in the CD
content to launch the menu.
ii) For Mac, double click the "Install Deckadance.mpkg" to install.
Please follow the on screen instructions to finish the installation. You will be asked to enter the serial number of the
software. The serial number can be found on the paper pocket of the Setup CD.
Please refer to www.djtechpro.com
The included Deckadance LE software supports only using X10 as an external mixer. Time Code is not supported.
6. When making connection, make sure all faders are at "zero" and all devices are off. First, connect all input sources
and processors. Next, connect your microphone and monitor headphones. Finally, connect the stereo outputs to the
power amplifier(s) and/or audio receivers such as tape decks. Plug your mixer into AC power. Now you are ready to
switch everything on.
IMPORTANT: Always switch on your audio input sources such as turntables or CD players first, then your mixer,
and finally any amplifiers. When turning off, always reverse this operation by turning off amplifiers, then your mixer,
and then input devices.
and www.deckadance.com for latest software update.
5
A. Open Deckadance Audio Setup, select
ASIO for Audio Driver and DJ-TECH X10
for Audio Interface
B. Select External Mixer for Outputs
C. Select Out 1 and Out 2 for Player A; Out
3 and Out 4 for Player B.
D. Select In 1 and In 2 for Deck 1; In 3 and
In 4 for Deck 2
A. Open Config, select Sound Setup Page.
B. Select ASIO Driver for Soundcard
C. Select TIMECODE or LINE-Ins for Inputs.
Select Chan 1&2: Deck 1/ Chan 3&4:
Deck 2.
D. Select External Mixer for Outputs. Select
Deck 1: Chan 1&2/ Deck 2: Chan 3&4.