HeatStar HS115TC Manual De Uso página 8

USING NOMAD HEATER ACCESSORIES
The Nomad line of forced air heaters is designed to be
used as a stand alone gas fired heating appliance. It is
also designed and certified to be used with a collection
of useful accessories. For information on any additional
accessories that may be available for your model refer
to the list of accessories in this booklet or visit www.
heatstarbyenerco.com.
USING NOMAD HEATERS WITH DUCT & DIFFUSERS
When using this heater to heat a party tent or construction
environment from out side of the space you will need to
employ the help of a few different diffuser attachments.
Direct Diffuser & Duct Adapter
A direct diffuser allows the user to duct the heat being
DUCT ADAPTER
the heater and turn clock wise to lock them in place. Next
you will need the flexible duct transition piece. The duct
transition is a short piece of special silicone lined ducting
that attaches the adapter to the End diffuser. With the
duct adapter attached to the heater, place the transition
duct piece over the outside of the adapter ring and
tighten down the strap. The other end of the Duct is then
attached to the diffuser see figure 6. The diffuser is an
accessory designed to help direct the air being discharged
from the heater. The air comes out of the diffuser and
spreads out in multiple directions to better fill the space
and heat more evenly. The channel on top of the diffuser
is designed to hold the tent material from falling in front
of the diffuser. The heater can be used without the
diffuser but it is recommended for more effective and
efficient use.
FIGURE 6
Long Duct & Diffuser
Nomad heaters are also designed to be used with 10'
of flexible duct for when distance from the area to be
Forced-Air Dual-Fuel NOMAD Construction Heater
produced by the Nomad
heater into a space needing
heat without having the
heater in that space. To
do this you will need a
duct adapter. The duct
adapter attaches to special
connection points on the
heater that match up to
the connectors on the
adapter. Align the tabs on
the adapter to the holes on
DIFFUSER
heated is needed or required. To use this setup you will
need the end diffuser and the 10' specially designed
ducting. To assemble attach one end of the 10' length of
duct to the duct adapter and the other to the end Diffuser.
Then place the end diffuser in the space to be heated.
FITS HS1 15TC
12" X 30" TRANSITION DUCT F109107 12" DUCT ADAPTER F109106
FITS HS190TC & HS250TC
16" X 30" TRANSITION DUCT F109117
12" X 10' SILICONE LINED
FLEXIBLE HEATING DUCT
F109108
16" X 10' SILICONE LINED
FLEXIBLE HEATING DUCT
F109118
12" UNIVERSAL DIFFUSER
F109105
16" UNIVERSAL DIFFUSER
F109115
8
Operating Instructions and Owner's Manual
16" DUCT ADAPTER F109116
FITS HS1 15TC
FITS HS190TC & HS250TC
FITS HS1 15TC
FITS HS190TC & HS250TC