Switch On The Appliance - Fagor IO-HOB-097 Manual De Instrucciones

OPERATION
Control Panel
• Immediately after the appliance is connected to electrical mains, all displays will light up
briefly. Your induction hob is then ready for use.
• The induction hob is equipped with electronic touch control sensor fields, which are oper-
ated by touching with a finger for at least 1 second.
• Touching of a sensor is accompanied by an acoustic signal to acknowledge.
No objects should be placed on the sensor fields (this could cause an error). Touch
sensor fields should be always kept clean.

Switch on the appliance

Touch and hold the on/off sensor for at least 1 second
(active) when "0"
If you do not set the desired heat setting of the cooking zone within 10 seconds of
activating the hob, the appliance will turn off automatically.
Activate cooking zone and set the heat setting.
• Turn on the hob with the
• Place the cookware on the desired cooking zone.
• The cookware will be automatically detected and the relevant display
hing "0."
When cookware is detected on more than one cooking zone touch the display
of the cooking zone you want to use. It will flash.
• To select the desired heat setting slide your finger across the
the left (the display will show the selected heat setting).
• The cooking zone operates.
A cooking zone is active when its display shows a digit or a letter. This indicates the
cooking zone is ready for the heat setting to be set or changed.
48
is shown on the display
sensor.
. Hob indicates correct operation
.
will show flas-
sensor starting from