Haier HC32TW10SB Manual Del Usuario página 11

INSTALLATION INSTRUCTIONS
STEP 2 - REVERSE DOOR
9. Remove the bottom hinge by removing the 3 screws.
Lift the hinge to remove.
10. Remove the hinge pin on the bottom hinge and
reinstall on the opposite side of the hinge.
11. Remove the 2 screws from the left side and relocate
to the right side.
12. Remove the two plug buttons on the left side at the center and install
them on the right.
13. Turn and relocate the center hinge to the left side and reinsert screws.
Do not tighten screws yet.
14. Align the fresh food door on the left center hinge. With the magnetic
gasket holding the door in place, make sure the door is aligned with the
refrigerator, and secure the bottom hinge on the left with 3 screws.
15. Ensure fresh food door is properly sealed and leveled before tightening
the center hinge screws and the bottom hinge screws.
16. Raise the refrigerator to the upright position.
17. Place the freezer door on the center hinge over the pin. Ensure the door
is aligned horizontally and vertically, and that the gasket seals on all
sides.
18. Turn and relocate the top hinge on the left side with screws.
19. Replace the hinge cover on top of the hinge by sliding it from front to
back.
20. Put the 2 plug buttons on the right side on top of the cabinet.
21. Open and close both the freezer and fresh food doors several times to
confirm each door is positioned correctly and the gasket is sealed well. If
this is not the case, please adjust the door again.
22. Wait at least 30 minutes before plugging in the refrigerator to allow the
refrigerant to settle down. Then plug in the unit.
49-60808-1
(Optional) (Cont.)
11