SEVERIN KS 9884 Instrucciones De Uso página 14

below.
- Fit the upper (10) and lower door mountings (13) to the door handle/bar (12).Use the
screws (9) to mount the handle on the door. Ensure that the handle is properly and
securely attached. Place the screw covers (11) over the screw heads.
Installation
The appliance should be set up in a well-ventilated, dry room. It should be operated in an
ambient temperature of 16 to 32 °C and a relative humidity of max. 70 %. Do not expose the
appliance to direct sunlight, and do not position it next to any heat sources (radiators,
cookers etc). If this cannot be avoided, however, a suitable insulation must be installed
between the heat source and the unit.
To ensure sufficient air circulation, maintain a minimum distance of 50 mm between the rear
of the unit and the wall. The clearance at the sides and top must be at least 15 mm.
If the floor is uneven, the adjustable feet on the unit can be used to compensate and ensure
optimum stability. The whole unit should be installed at a slight angle in such a way that it
leans to the rear: this will ensure that the door closes automatically. However, both front
feet must be set to the same height.
Ventilation
The heated air around the rear of the unit must be able to circulate freely. Therefore, ensure
that the air circulation behind the unit is not obstructed.
Reversible door
The design provides for the door to be reversed, i.e. for
right-hinged (default installation) to become left-hinged.
- Take off the door handle by first removing the screw
covers and then taking out the two screws.
- Remove the two screw covers (A) on the top of the
unit.
- Take out the two screws and then slightly lift the top
cover (B) of the unit, slide it forward and carefully
take it off.
- Tilt the unit backwards and secure it in this position
(e.g. using suitable wedges).
- Remove the three screws on the upper hinge and take it off.
- Replace the two upper-hinge screws in the housing in the same
way as they appear on the left.
- Open the door a little way and take off the lower hinge after
removing the two screws.
- Unscrew the adjustable foot on the left-hand side and re-fit it
on the right.
- Fit the lower hinge on the left side of the unit using the two
screws. Place the door on to the lower hinge pin and close it.
- Remove the two screws on the new, upper-hinge position and
fit the upper hinge on the left-hand side, using the three screws
to secure it. Make sure that the hinge pin sits properly in the
corresponding hole in the door frame.
- Replace the top cover (B) of the unit in such a way, that it extends slightly forwards, and
then slide it back. Note that the front edge goes under the edge of the housing below the
14