Craftsman 536.881113 Manual De Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

How To Install
The Speed Control
Rod
1. Put the speed select lever into the
sixth gear position.
2. Attach the speed control rod (end
with 90 ° bend) to the speed select
bracket with washer and cotter
pin. See Figure 10.
3. Put the speed select lever into the
first gear position.
4. Attach the trunnion,
located on the
bottom end of the speed control
rod, to the shift yoke assembly.
See Figure 11. The fasteners
are
attached to the trunnion
at the
factory.
5. The length ot the trunnion
and
speed control
rod have been pre-
adjusted at the factory. If an adjust-
ment is required, see "How To
Adjust The Friction Wheel" in the
Service And Adjustment section.
6. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
Speed
Control
Rod
Speed
Select
Bracket
\
Cotter Pin
Speed Select
Lever
Washer
Cotter Pin
/
_
Figure 10
Speed Control Rod
Trunnion
Shift Yoke
Washer
Figure 11
How To Assemble
The Chute Deflector
1. Remove the carriage bolt. See
Figure 12.
4.
2. Raise the chute deflector into op-
erating position.
5.
3. Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
Fasten with washer and Iocknut.
Tighten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
Chute
Deflector
Operating Position j._
\
/
Carriage,_
Bolt
F-021050L
Flang_
Washer
Nut #,
1o
Figure 12

Publicidad

Tabla de contenido
loading

Tabla de contenido