The operation ofanysnow thrower can
result i nforeign o bjects b eing thrown
intotheeyes, which c anresult inse-
vere eyedamage. Always w ear s afety
glasses oreyeshields while operating
thesnow thrower.
Werecommend
standard safety
glasses orawide vision safety m ask for
over y our g lasses.
_
ARNING: Read Owner's
Manual before operating
machine. Never direct dis-
charge toward bystanders. Stop the
engine before unclogging discharge
chute or auger housing and before
leaving the machine.
TO STOP YOUR
SNOW THROWER
1. To stop throwing snow, release the
auger drive lever. See Figure 15.
2. To stop the wheels, release the
traction
drive lever.
3. To stop the engine, push the
throttle
control
lever to off and pull
out the ignition
key.
Auger Drive Lever
Traction Drive Lever
Shift Lever
Crank
Assembly
Figure 15
TO CONTROL SNOW DISCHARGE
1. Turn the crank assembly
to set the
direction of the snow throwing.
2. Push the remote chute lever for-
ward to discharge the snow high
and far. Pull the remote chute le-
ver back to discharge the snow
down.
HOW TO MOVE FORWARD AND
BACKWARD
1. To shift, release the traction drive
lever (left hand) and move the
speed shift lever to the speed you
desire. See Figure 15. Ground
speed is determined by snow condi-
tions. Select the speed you desire
by moving the speed shifter lever
left into the appropriate notches on
the shift lever plate:
Speeds 1, 2- Wet, Heavy
Speed 3- Light
Speed 4 - Very Light
Speed 5, 6 - Transport only
2. Engage the traction drive lever (left
hand). As the snow thrower starts
to move, maintain a firm hold on the
handles, and guide the snow throw-
er along the clearing path. Do not
attempt to push the snow thrower.
3. To move the snow thrower back-
ward, move the speed shifter lever
right into first or second reverse and
engage the traction drive lever (left
hand).
IMPORTANT:
Do not move the speed
shifter lever while the traction
lever
is down.
TO THROW
SNOW
1. Push down the auger driver lever
(right hand). See Figure 15.
2. Release to stop throwing snow.
F-021050L
13