Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT
SPECIFICATIONS
CHAIN LUBRICATION
EVERY 25 HOURS
HORSEPOWER
11 HP
DISPLACEMENT
21.82 cu. in.
GASOLINE
4 quarts
CAPACITY
(unleaded)
OIL CAPACITY
5W30
(20 oz capacity)
SPARK PLUG:
Champion RJ19LM
(Gap .030 in.) or
equivalent
VALVE CLEARANCE:
Intake: .010 In.
Exhaust: .010 In.
SNOW THROWER
AUGER DRIVE BELT
Adjust the auger drive belt after the first
2 to 4 hours of use, again about mid-
season and twice each season thereaf-
ter (See "Belt Adjustment"
in the
Service and Adjustment
section).
1.
2.
3.
4.
5.
Position speed selector lever in first
(1) forward gear.
Stand the snow blower up on the
auger housing end.
NOTE: When the crank case if
filled with oil, do not leave the
snow blower standing
up on the
auger housing
for an extended
period of time.
Remove the bottom panel.
Lubricate the chains with a chain
type lubricant.
For storage, wipe the hexshaft
and
sprockets
with 5W30 motor oil.
NOTE: Clean all excess grease or
oil found on the rubber friction
wheel or the disc drive plate.
CAUTION: Do not allow grease or
oil to contact the rubber friction
wheel or the disc drive plate.
6. Install the bottom panel.
AUGER SHAFT LUBRICATION
EVERY 10 HOURS
1.
2.
Lubricate the Zerk fittings (A) every ten
hours with a grease gun.
Each time a shear bolt is replaced,
the auger shaft MUST be greased.
See Figure 18. See To Replace Au-
ger Shear Bolt in the Service and
Adjustment
section.
A
Figure 18
F-021050L
Figure 19
19
AUGER GEAR BOX
The auger gear box is lubricated at the
factory and should not require addition-
al lubrication.
If for some reason the
lubricant should leak out, have auger
gear case checked by a competent re-
pairman.
Publicidad
Tabla de contenido
