Craftsman 536.889251 Manual Del Usuario página 12

How To Set The Drift Cutters
Drift cutters are used to cut a path
through snow deeper than the auger
housing.
1. Loosen the wingnuts that secure the
drift cutters to the auger housing.
See Figure 12.
2. Raise the drift cutters to the desired
height.
3. Tighten the wingnuts.
Wingnul
Drift Cutter
Figure 12
_" CHECKLIST
Before you operate your new snow throw-
er, to ensure that you receive the best
performance and satisfaction from this
quality product, please review the follow-
ing checklist:
_" All assembly instructions have been
completed.
_" The discharge chute rotates freely.
No remaining loose parts in carton.
_" On electric start models, the unit was
shipped with the starter cord plugged
into the engine. Before operating, un-
plug the starter cord from the engine.
While learning how to use your snow
thrower, pay extra attention to the follow-
ing important items:
_" Engine oil is at proper level.
_" Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline.
_" Become familiar with all controls-their
location and function. Operate controls
before starting engine.
Fu031068L 12