Warm Start - Craftsman 536.889251 Manual Del Usuario

Choke Knob Recoil Starter Handle
\\\
4. Move throttle control to "FAST"
position. Operate the engine with
the throttle control in the "FAST"
position (see Figure 21).
Throttle Control
/
Figure 21
5. Remove the ON/OFF keys from the
plastic bag. Insert one of the
ON/OFF keys into the key slot (see
Figure 22). Make sure the key
snaps into place. Do not turn the
ON/OFF key. Keep the second ON/
OFF key in a safe place.
Figure 23
7. (ELECTRIC START) Connect the
power cord to the engine and de-
press the starter button.
Connect
Power Cord
Starter Button
Figure 24
8. As the engine warms up, move
choke lever to "1/2 choke" position.
When engine runs smoothly, move
choke lever to "No Choke" Posi-
tion.
9. Run engine at full throttle "FAST"
when throwing snow.
Allow the engine to warm up for several
minutes before blowing snow in temper-
atures below 0°F.
Figure 22
6. (RECOIL STAR'r) Rapidly pull the
starter handle (see Figure 23). Do
not allow the recoil starter handle
to snap back, but allow it to rewind
slowly while keeping a firm hold on
the starter handle.
F-031068L
18
WARM START
If restarting a warm engine after a short
shutdown, leave choke at "OFF" and do
not push the primer button. If the en-
gine fails to start, follow the Cold Start
instructions.
FROZEN STARTER
If the starter is frozen and will not turn
engine:
1. Pull as much rope out of the starter
as possible.