Panasonic EYFGA1N Manual De Instrucciones página 13

LED light setting
• You can select from two LED light modes.
1. Set the tool to setting configuration mode.
(See page 10.)
. Press the B button once.
• The current setting value will be dis-
played.
3. Press the and
desired LED mode.
Display
L1 Linked to LED light button
L2 Linked to trigger switch operation
4. Press the OK button to accept the new
setting.
NOTE:
• The tool ships with the LED light mode
set to L1 by default.
Speed control function
• The speed (RPM) can be changed with the
amount of depression of the trigger.
1. Set the tool to setting configuration mode.
(See page 10.)
. Press the B button three times.
• The setting value will be displayed.
3. Press the and
setting to ON or OFF.
Operation
P0
P1
4. Press the OK button to accept the new set-
ting.
Initializing all settings
Factory settings
• Speed adjustment function
→ GA1: 80 GA2: 75 GA3: 45
• Auto downshift function → 0
• Cross thread reduction function → R0
• Rundown error detecting function → 0
• Maintenance interval alarm function
→ 0
• Radio signal range limitation function
→ C0
• Buzzer setting → b0
• LED light setting → L1
• Speed control setting → P0
buttons to set the
Function
buttons to change the
Function
Speed control ON
Speed control OFF
• This section explains how to revert all tool
settings to their default values at the time of
shipment from the factory.
• The error display will be turned off.
1. Set the tool to setting configuration mode.
(See page 10.)
. Press the C button.
• The control panel will begin flashing.
Display: The letter "F" flashes on and off.
Battery indication lamp: The upper and
lower bars of the battery flash on and off.
Display
3. Press the OK button to accept the select-
ed setting.
• The control panel will stop flashing and
light up.
Checking tool settings
• When the tool stops, the current setting
value will be displayed for approximately 2
seconds.
• The setting status cannot be checked while
the tool panel is off. Depress the trigger
switch once to turn on the panel.
Checking the status of the speed
adjustment and buzzer settings
1. Press the A button.
• The RPM and buzzer setting values will
be displayed (in that order).
Example: If the RPM is set to 500 min
and the buzzer is set to sound at the
green indicator,
"50" → "b1"
Checking the status of the LED light
and rundown error detecting func­
tion and speed control function set­
tings
1. Press the B button.
• The LED light and tightening time and
speed control setting will be displayed
(in that order).
Example: If the LED light mode is set to
L1 and the tightening time is set to 20
and speed control is set to ON,
"L1" → "20" → P0
- 13 -
Battery indication lamp
-1