Wall Mounting Ldmg2Ik1 - LD Systems MAUI G2 Manual De Usuario

WALL MOUNTING LDMG2IK1

1. Attach the two supplied terminal block connectors to a 4-core speaker cable (4 x 1.5 mm²), ensuring that they are wired in parallel (see
printed configuration on adapter) and plug the connectors into the designated column and subwoofer terminals on the adapters. Now, from
underneath, push the adapter with the 4 rubberised holes on to the speaker column as far as it will go (slightly loosen the 3 mm hexagonal
grub screw if necessary) and secure to the adapter using the two grub screws. The electrical contact for the signal supply to the speaker
column will be automatically established.
2. Using screws, attach mounting rail A in a suitable position to a solid wall, with its flat side and with the tabs facing upwards (6 screws,
"THIS S IDE UP" facing upwards). Use suitable screws and plugs etc. to ensure secure mounting. Remove the 6 grub screws (3 mm
hexagonal socket) from the appropriate locations on the rear of the speaker column and attach the flat side of the mounting bracket B to the
MAUI G2 speaker column using the supplied bolts (M5 x 10 mm, 4 mm hexagonal socket). Observe the instruction "THIS SIDE UP" on the
mounting bracket.
3. + 4. Now slide the speaker column with the mounting bracket rail into the mounting rail on the wall in such a way that the retaining tabs on
the mounting rail slot into the recesses of the mounting bracket, and then push the column downwards into its fixed location (approx. 10 mm).
5. Secure installation with the supplied locking screw (M4, 3 mm hexagonal socket). The corresponding thread is located at the base of the
speaker column mounting bracket.
6. From above, now push the adapter with the steel pins onto the subwoofer as far as it will go.
1
3
2
4
5
B
A
7