Wall Mounting Ldmg2Ik2 - LD Systems MAUI G2 Manual De Usuario

WALL MOUNTING LDMG2IK2

1. Remove the 6 grub screws (3 mm hexagonal socket) from the appropriate locations on the rear of the speaker column and attach the flat
side of mounting bracket A to the MAUI G2 speaker column using the supplied bolts (M5 x 10 mm, 4 mm hexagonal socket). Observe the
instruction "THIS SIDE UP" on the mounting bracket (this side facing upwards).
2. Slightly loosen bolt E (do not remove), loosen and remove bolt D from the tilt & swivel arm, remove and lift the U-bracket B from its
mounting. Firmly attach U-bracket B in the desired position on mounting bracket A with the 3 supplied screws (M5 x 10 mm, 4 mm hex
socket) (for maximum tilt, use the lowest of the 3 positions – MAUI 11 G2 = max. 22°, MAUI 28 G2 = max. 12°).
Using screws, attach mounting plate C vertically in a suitable position to a solid wall with its flat side and safety eyelet facing upwards (6
screws). Use suitable screws and plugs etc. to ensure secure mounting.
Now attach the two supplied terminal block connectors to a 4-core speaker cable (4 x 1.5 mm²), ensuring that they are wired in parallel (see
printed configuration on adapter) and plug the connectors into the designated column and subwoofer terminals on the adapters. Now, from
underneath, push the adapter with the 4 rubberised holes on to the speaker column as far as it will go (slightly loosen the 3 mm hexagonal
grub screw if necessary) and secure to the adapter using the two grub screws. The electrical contact for the signal supply to the speaker
column will be automatically established.
3. Now slide the speaker column with the attached U-bracket B into the bracket on the wall, reinstall bolt D into its designated position and
secure it with the previously removed nut.
4. The speaker column can be tilted vertically by slightly loosening nut E, adjusting to the desired angle and then re-tightening the nut.
The column can be adjusted horizontally by loosening nut F (remove plastic cap beforehand), adjusting the angle as required, and then
re-tightening the nut.
5. From above, now push the adapter with the steel pins onto the subwoofer as far as it will go.
1
D
3
B
A
C
D
C
B
2
E
B
D
F
4
E
F
C
9