Sleep Mode; Failures And Blocks; Battery Status And Charging - Vermeiren LiNX 400 Manual De Instrucciones

4.1.2 Sleep mode

The operating console will go into sleep mode after a period of inactivity (default 5
minutes).
When the system sleeps, it is partially turned off to reduce energy consumption.
To reactivate the operating console, press a button or move the joystick.

Failures and blocks

4.2
When the operating console is powered and a failure
appears, the indicator of the ON/OFF button starts
blinking in red, see picture. The number of blinks
indicates the fault code. For a few seconds, a triangle
with fault code (A) is displayed. The ON/OFF button will
keep blinking.
In case of a failure, one or all functions of the operating console are blocked. This is
indicated by the "forbidden"-symbol and the yellow warning bars (B).
The status is indicated by a small symbol (C) in the top corner of each screen.
For more information, see §5.

Battery status and charging

4.3
WARNING
Follow the charging instructions in the wheelchair instruction manual and the suppliers'
manual of the battery charger.
The battery charge indicator (located at the top of the touchscreen)
provides an estimation of the remaining battery capacity.
In the following table all battery indications and their meanings are
collected.
Risk of injuries and damage
A
Failure indication and drive inhibited
7
LiNX 400
2019-01
Operating console functions
C
B
Battery status indication
EN
NL