Service And Maintenance - Elite SI7160 DV Manual De Instrucciones

5. Service and Maintenance

Maintenance
The device is constructed for long service with a minimum of maintenance. Long term satisfactory
operation depends on the correct care of the device and regular cleaning.
Cleaning – first remove the power plug
Regularly clean the device using a soft cloth, preferably after every use. Keep the ventilation slots
free of dust and dirt. If the dirt cannot be easily removed, use a soft cloth dampened with soapy
water. Never use solvents such as petrol, alcohol etc. These solvents can damage plastic parts.
Lubrication
The device requires no additional lubrication.
Diagnose
If the machine can't work normally, stop using it at once and use the following table to find the
possible reason and solution.
Fault
No output
Low current
Bad welding line
If it's not the reasons listed above, send the welding machine to our service center or responsible
vender for help.
Warning: Never try to fix the welding machine yourself, never open the enclosure. We are not
responsible for any accident resulting from your improper dealing with the machine.
ELITE SI7160DV / SI6130LV
Possible reasons
• No supply.
• Improper fuse or breaker.
• Thermal protection actuated.
• Poor connection
• Grounding clamp too far from the
position need to weld.
Bad electrode.
Solution
• Check the power connection.
• Replace an appropriate fuse or breaker.
• Waiting for about 5 minute.
• Check the grounding clamp to ensure good
connection. Clean the rust or paint if any.
• Move the clamp to be closer to the position to
weld.
Change a new electrode.
9