Publicidad
small clearance on its upper surface. This clearance is to avoid the propeller to be p ushed out of
center by a key which is too tall.
B) Apriete la tuerca para posteriormente bloquearla con los dos tornillos suministrados a ese fin
Tighten the nut and secure it in place using the two allen head screws.
C) Rellene la hélice con la grasa marina suministrada usando el engrasador. Eventualmente la hélice puede
suministrarse llena de grasa. La hélice MAX PROP® CLASSIC GENERAZIONE 2 funciona de modo
correcto cuando está totalmente llena de grasa. Compruebe que la grasa sale por las juntas de las
piezas centrales del nucleo, así estaremos completamente seguros que toda la superficies con fricción
están perfectamente lubricadas. La grasa dbe ser fluida para garantizar el buen funcionamiento es
necesario proceder al reengrasado después de un año bajo el agua.
Fill the prop with marine grease (supplied) using the grease fitting (supplied) inserted into the grease
holes marked "GREASE" . The MAX PROP®CLASSIC GENERATION 2 propeller works properly
only if the central body is completely filled with the correct grease. Verify that the grease is oozing from
the rotating joints between the central part and the hub , so that all of the moving surfaces are perfectly
oiled. The grease used must be a type of grease approved by MAX PROP® so it will remain fluid after
years of use and will not get too stiff in cold water
D) O r i e n te la s p a la s e n l a p o s ic i ó n d e b an d e r a ( de b e e s t a r pe rfe c t a me n te a li n ie a das l a s
p a l a s co n e l e je . Pr e s t e at e nc i ó n q ue el p e r fi l c o r re c t o qu e m u e st re s e a e l q ue
a p a re c e e n la Fi g 4 .
Move the blades into the feathered position, making sure that the rounded trailing edges of the blades
are aft as shown in Fig. 4
Fig.4
www.max-prop.info
6
Publicidad
