Fcc Compliance Statement - Epson WF-M5299 Manual Del Usuario

• No presione con demasiada fuerza sobre la pantalla LCD y no la sujete a impactos duros.
• No utilice un objeto puntiagudo o afilado, como un bolígrafo o su uña, para operar la pantalla LCD.
• Si la pantalla LCD se rompe o agrieta, no toque o intente retirar las piezas rotas; comuníquese con
Epson para obtener asistencia.
• No someta el producto a cambios bruscos de temperatura o humedad; esto podría causar que se
produzca condensación dentro de la pantalla LCD y degradar su rendimiento.
Tema principal:

FCC Compliance Statement

For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification or Declaration of this device and may cause interference levels which exceed the limits
established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded
equipment interface cable with this device. If this equipment has more than one interface connector, do
not leave cables connected to unused interfaces. Changes or modifications not expressly approved by
the manufacturer could void the user's authority to operate the equipment.
For Canadian Users
CAN ICES-3(B)/NMB-3(B)
Tema principal:
Instrucciones importantes de seguridad
Avisos
239