Hama EWS-152 Instrucciones De Uso página 8

6.2 Basic and manual settings
Automatic setting using the DCF signal
• After the base station is switched on for the rst time and successful transmission
is established between the base station and the measuring station, the clock will
automatically search for a DCF signal. During the search, the wireless symbol (6)
will ash.
Display
Flashing
Displayed continuously
No display
• If the station still does not receive a signal, press and hold the
approx. 3 seconds to start the manual search for the DCF signal. The wireless
symbol (6) will start to ash.
Note – Time settings
• The search process takes about 7 minutes. If the search fails, it ends and is
repeated at the next clock hour. The wireless symbol (6) will go out.
• In the meantime you can, however, set the time and the date manually.
• The clock automatically continues to search for the DCF signal on a daily basis
(between 1:00 a.m. and 3:00 a.m.). If the signal is received successfully, the
manually-set time and date are overwritten.
Searching for the DCF signal
Active
Successful – signal is being received
Deactivated
button (9) for
7