EDIFIER R2000DB Manual De Usuario página 6

Operational guide
EDIFIER R2000DB
setup
① Turn on R2000DB speakers and switch to Bluetooth mode by pressing the Bluetooth button on the remote
or pushing the volume dial on the back panel of the active speaker until the indicator LED turns blue.
② Set your input device (mobile phone, tablet device, MP3/MP4 player etc.) to search for Bluetooth device and
select "EDIFIER R2000DB".
③ Pair your device with "EDIFIER R2000DB".
④ Play the audio on your device and adjust the volume to a desired level.
⑤ To disconnect Bluetooth: Press & hold
Note:
software versions of source devices.
3. PIN code for connection is "0000" if needed.
7
English
Total power output: RMS 24W × 2 (treble) + 36W × 2(bass) (DRC ON)
Signal to noise ratio: ≥85 dBA
Frequency response: 50Hz ~ 20 KHz (+/-3db)
Input sensitivity: Line in1: 800 mV ± 50 mV
Line in2: 600 mV ± 50 mV
OPT: 500 mFFs ± 50 mFFs
Input type: RCA/Bluetooth/Optical
Bass driver: 5 inch (132 mm)
Treble driver: Φ25 mm silk dome tweeter
8
English