Installation; Packaging And Unpacking; Installation (Service Technician) - Bartscher FTE91MA0 Manual De Instalación, Uso Y Mantenimiento

7. PROBLEMS DURING OPERATION
The information below is provided to recognize
and repair any failures that may occur when
operating the device.
Problem
The heating coils do not heat
up.
8.

INSTALLATION

8.1.

Packaging and unpacking

During unloading and when installing the device
follow the information from the manufacturer
placed directly on the packaging and in this
manual.
To lift and transport the product plan to use a fork
lift or stacker, and pay attention to even weight
distribution to avoid a risk of tilting of the
packaging (avoid excessive incline!).
When using the lifting equipment
pay attention to the mains cable and
feet position.
The packaging consists of the carton packaging
and wooden pallet. There are symbols printed on
the carton packaging that according to the
international agreements
regulations to follow when loading and unloading,
transporting and storing the device.
THIS CAUTION
SIDE UP GLASS
Cause
The electrical connection is not
correct.
Safety thermostats are on.
Damaged
controller.
inform about the
KEEP DRY
9
Some of the failures can be repaired by the user,
others require thorough specialist knowledge.
Such problems may be solved exclusively by the
qualified personnel.
Check the electrical connection.
Reset the device (see special
section).
Replace switch.
temperature
Contact the service company.
When collecting the goods check if the packaging
is complete and has not been damaged during
transport.
Any damage should be immediately reported to
the shipping company.
Unpack the device as soon as possible to check if
the device is not damaged.
Do not use a sharp object to cut the carton box. It
may damage the stainless steel inside the box.
Remove the carton packaging from bottom to top.
When unpacked check if the device is according
to the order.
In case of any difference inform the sales agent
immediately.
Do not store the packaging
materials (nylon bags, polystyrene
foam, clips ...) in the reach of children!
Remove the protective PVC layer from the out
and inner surfaces. If possible, do not use any
metal tools.
ENGLISH
Solution
GB