Tabla De Contenido; Installation; Important Information; Positioning - Bartscher HI LITE Manual De Instalación Y Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ENG
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE DUE TO INCORRECT
INSTALLATION, TAMPERING, IMPROPER USE, FAULTY MAINTENANCE, FAILURE TO
OBSERVE THE CURRENT REGULATIONS AND INCOMPETENCE.
THE MANUFACTURER RESERVES THE RIGHT TO MODIFY WITHOUT NOTICE THE
APPLIANCE CHARACTERISTICS DESCRIBED IN THIS HANDBOOK.
CONTENTS
1.
1.1
1.2
1.3
2.
2.1
2.2
3.
3.1
3.2
settinG
4.
4.1
4.2
4.3
4.4
5.
5.1
Routine MaintenanCe
6.
TECHNICAL CHART
7.
TECHNICAL DRAWINGS
12
1.
1.1
Read this handbook through carefully as it provides important information about safely
installing, using and servicing the unit. Keep the handbook in a safe place for future
reference by the various operators.
The unit must be installed by professionally qualified personnel in accordance with
the manufacturer's instructions.
The unit must be used only by people who have been trained to use it.
13
do not leave the unit unattended during use.
13
Do not allow children near the equipment.
during operation the equipment reaches high temperatures. Be careful, BuRn
13
HAZARD!
14
Turn the unit off in the event of a failure or malfunction. Repairs should only be
carried out by an authorised repair centre using original parts.
15
failure to do so could compromise unit safety.
15
The unit conforms to the following standards:
15
low voltage directive 2006/95/EC;
e.M.C. directive 89/336/eeC concerning electromagnetic compatibility;
16
current accident prevention and fire regulations;
current regulations on installation of electrical systems;
16
hygiene standards.
17
19
19
19
1.2
20
20
Remove the unit from the packaging and make sure it is in perfect condition.
21
21
52
53-60
fig. 1
Take the protective film off the outer panels, pulling it away slowly so no traces of glue
are left.

IMPORTANT INFORMATION

POSITIONING

Before installing the appliance, remove the two screws blocking the
heating element from the back (fig. 1)
Place the unit where it is going to be used, keeping it away from walls,
flammable cladding materials or other flammable parts. Position the
salamander under an exhaust hood to guarantee complete aspiration of
the steam produced when cooking. Do not install the appliance above
hot surfaces.
level and adjust the height of the unit by means of the levelling feet.
ENG
13

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido