Installation Of The Appliance In A Line - Bartscher FTE91MA0 Manual De Instalación, Uso Y Mantenimiento

Connect the switch-off to the terminal strip (B)
of the device, as shown in the drawing and
block diagram (see the attachments). Use
cable type H07RN-F or better, min. heat
resistance of 80 °C.
Firmly press the end of the cable (C).
Replace the terminal strip cover.
B
C
8.4.

Installation of the appliance in a line

To fix the appliance in a line (neighboring) follow
the steps:
1. Dismantle the control panel, and remove the
cast iron frame from the chimney if necessary.
2. Apply the sealing tape (A) onto the joining
sides.
B
The device is equipped with the equipotential
clamp (M). The terminal is marked with
appropriate sticker:
M
3. Place the appliances next to each other and in
a horizontal position (by adjusting the feet).
4. Connect the appliances with the joining
elements.
C
A
11
ENGLISH
.
A
C
GB