Safety - Bartscher FTE91MA0 Manual De Instalación, Uso Y Mantenimiento

3.

SAFETY

Read carefully the guidelines and
instructions in the instruction manual
before you use the device.
The instruction manual
information on how to safely use and maintain the
device. Retain the manual for future reference.
Electric installation conforms to CE EN
60335-1 and 60335-2-38 regulation.
To prevent any hazard, the
damaged mains power cable may be
replaced by the manufacturer or
service personnel only.
The manufacturer took extra care when designing
and manufacturing to prevent any safety or health
hazard to the personnel operating the device.
Please read carefully the guidelines in the
instruction manual and instructions placed directly
onto the device. Above all, observe all the safety
instructions.
Do not intervene in or remove the protective
device installed in the device. Non-compliance
may lead to severe safety and health hazard
against people. We recommend to perform a few
tests to know the layout and main functions of the
control panel, particularly those to switch the
device on and off.
The device is intended only for the use it has been
designed for and any other use is considered as
the use not in compliance with the intended use.
The manufacturer is not liable for material
damage or damage to person caused by
misapplication or incorrect application of the
device.
Any maintenance work that requires special
technical license or special skills may be
performed by qualified personnel only.
contains general
3
To provide hygiene and protect foods from dirt, all
the elements that have direct or indirect contact
with the foods and all border areas must be
thoroughly cleaned. Use only the cleaning agents
intended for use in contact with food and avoid
using flammable agents or harmful to health.
After each use of the device make sure that all the
heating elements and control elements have been
switched off and the cable unplugged.
In case of prolonged interval in using the device
disconnect all power supply cables and thoroughly
clean the inside and outside elements of the
device.
In direct connection to the mains
the safety switch should be supplied
where wire joints dilation is large
enough to secure disconnection in
category III overvoltage, which is in
accordance with the installation rules.
The device requires some safety
measures during installation, positioning,
fixing, and connecting to the power supply
(section 8 "INSTALLATION").
Do not clean the device with direct
stream of water
.
ENGLISH
GB