Sony XVM-B62 Manual De Instrucciones página 9

1
Choose the mounting position,
then shape the base of the monitor
stand to match the mounting
surface.
Bend the base gently so there are no
gaps between the base and the
mounting surface.
2
Peel off the protective film from
the base of the monitor stand and
attach the base to the mounting
surface.
Make sure the base attaches to the
mounting surface completely.
Notes
• The double-sided tape will not stick
firmly if the mounting surface
temperature is less than 20 °C. Use a
hairdryer, etc. to warm up the
mounting surface before mounting.
• Consider carefully the mounting
position beforehand. If you change
the position soon after mounting the
double-sided tape will be weakened.
• When removing the monitor stand,
preheat the mounting surface with a
hairdryer then slowly peel up to
remove.
Monitor stand
3
Fix the stand with the supplied
screws.
Note
Before drilling holes in the mounting
surface, make sure there is nothing
behind the dashboard.
4
Adjust the height.
When the monitor is at the right
height, tighten the clamp. To keep
the monitor from rattling while
driving, make sure the back or
bottom of the monitor is resting
firmly on the mounting surface.
5
Adjust the angle.
Loosen the lever and adjust the
angle. After this adjustment, tighten
the lever to fix the angle.
Lever
Screws
Clamp
9