Messages - Sony WX-810UI Manual De Instrucciones

Messages

The following messages may appear or flash during
operation.
INVALID
 The selected operation could be invalid.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
(underscore): The character cannot be
displayed.
For CD playback:
CD ERROR: The disc cannot be played. The disc will
be ejected automatically.
 Clean or insert the disc correctly, or make sure the
disc is not blank or defective.
CD NO DISC: There is no disc.
 Insert a disc containing playable files (page 14).
CD NO MUSIC: There is no playable file. The disc
will be ejected automatically.
 Insert a disc containing playable files (page 14).
CD PUSH EJECT: The disc could not be ejected
properly.
 Press  (eject).
or : The beginning or the end of the
disc has been reached.
For USB device playback:
HUB NO SUPPORT: USB hubs are not supported.
IPOD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start playback.
NOT SUPPORT ANDROID MODE
 A USB device not supporting AOA (Android Open
Accessory) 2.0 is connected to the unit while [USB
MODE] is set to [ANDROID].
 Set [USB MODE] to [MSC/MTP] (page 10).
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEVICE: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable files
(page 14).
USB NO SUPPORT: The USB device is not
supported.
 For details on the compatibility of your USB
device, visit the support site on the back cover.
USB OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SRC to
select another source.
 The USB device has a fault, or an unsupported
device is connected.
For steering wheel remote control
operation:
ERROR: An error occurred during the function
registration.
 Register again from the function where the error
occurred (page 10).
TIMEOUT: The function registration failed due to a
timeout.
 Try completing the registration while [REGISTER]
is blinking (about 6 seconds) (page 10).
For firmware update operation:
FILE ERROR: The updater is not stored in the USB
device.
 Store the updater in the USB device, then try
again (page 12).
UPDATE ERROR PRESS ENTER: Firmware update is
not completed properly.
 Press ENTER to clear the message, then try again.
During the update, do not turn the ignition to the
OFF position, nor remove the USB device
(page 12).
If these solutions do not help improve the situation,
consult your nearest Sony dealer.
If you take the unit to be repaired because of CD
playback trouble, bring the disc that was used at
the time the problem began.
17
GB