Getting Started; Resetting The Unit; Switching The Fm/Am Tuning Step; Setting The Clock - Sony WX-810UI Manual De Instrucciones

Getting Started

Resetting the Unit

Before operating the unit for the first time, after
replacing the car battery, or changing the
connections, you must reset the unit.
1
Press DSPL and EQ for more than 2
seconds.
Note
Resetting the unit will erase the clock setting and some
stored contents.
Switching the FM/AM Tuning
Step
Set the FM/AM tuning step of your country. This
setting appears only while the source is off and
the clock is displayed.
1
Press MENU, rotate the control dial to
select [GENERAL], then press it.
2
Rotate the control dial to select [TUNER
STEP], then press it.
3
Rotate the control dial to select from
[50K/9K], [100K/10K] or [200K/10K], then
press it.

Setting the Clock

1
Press MENU, rotate the control dial to
select [GENERAL], then press it.
2
Rotate the control dial to select [CLOCK
ADJ], then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press /
(SEEK –/+).
4
After setting the minute, press MENU.
The setup is complete and the clock starts.
To display the clock
Press DSPL.
6
GB

Checking the Battery Voltage

You can check the current battery voltage. (Not
available while the source is off and the clock is
displayed.)
1
Press DSPL repeatedly until the battery
voltage display appears.

Connecting a USB Device

1
Turn down the volume on the unit.
2
Connect the USB device to the unit.
To connect an iPod/iPhone, use the USB
connection cable for iPod (not supplied).