Getting To Know Your Two Tier Egg Cooker; Before Using For The First Time; Egg Cooker Assembly - Bella 14761 Manual De Instrucciones

Getting to Know Your Two Tier Egg Cooker

Product may vary slightly from illustration
Figure 1
Lid Handle
BPA free Tritan Lid
with Steam Holes
Egg Tray
Extension Shell
Egg Tray
Base with Water
Reservoir
Control Dial with
Illuminated Light Ring

Before Using for the First Time

1. Carefully unpack all parts of your Egg Cooker. Set the base aside.
2. Wash all parts (except the base) in warm, soapy water. Dry thoroughly.
3. Wipe the base's water reservoir with a damp, non-abrasive cloth.

Egg Cooker Assembly

1. Place the Egg Cooker base on a clean, dry, level surface.
2. Add either of the egg trays securely over the bottom lip of the base
3. Rinse eggs to be boiled (1 to 8). Use the piercing pin located on the underside of the measuring cup to
pierce the top (narrow) side of the egg. Be sure to rinse the pin after each piercing.
4. Place up to 4 eggs in the bottom egg tray. If more than 4 eggs are to be boiled, use the extension shell
to extend the Egg Cooker.
5. Fit the smaller, bottom of the extension shell into the bottom rack.
6. Position the top rack so that it fits into the fluted rim of the extension shell.
7. Place up to 4 additional eggs in the top egg tray.
8. Add the clear lid, fitting the smaller, bottom of the clear lid into the fluted rim of the egg tray.
IMPORTANT: Place the lid with steam vent facing the rare end to avoid burns during the cooking
process.
SO-315846_14761, 14781_BELLA_Egg Cooker_IM_R6.indd 7
7
Measuring Cup with
Egg Piercing Pin
POWER
Indicator Light
Polarized Plug
2019-03-08 4:23 PM